Skip to main content

MATEKSYS F722-STD

Description​

STM32F722RET6, ICM20602, BMP280, BF OSD, SD Card Slot, VCP+5x UARTs, 6x PWM / DShot outputs

MCU, Sensors and Features​

Hardware​

  • MCU: 216MHz STM32F722RET6
  • IMU: 32K ICM20602 gyro/accelerometer (SPI)
  • Baro: BMP280 (I2C)
  • OSD: BetaFlight OSD w/ AT7456E chip
  • Blackbox: MicroSD card slot (SD/SDHC)
  • VCP, UART1, UART2, UART3, UART4, UART5
  • PPM/UART Shared: UART2-RX
  • Battery Voltage Sensor: 1:10 (Max.36.3V supported)
  • Current Sensor: No (FCHUB-6S, FCHUB-VTX option)
  • BEC 5V: No (FCHUB-6S, FCHUB-VTX option)
  • LDO 3.3V: Max.300mA
  • I2C1 SDA & SCL: Yes
  • Camera control: Yes
  • DAC: Yes
  • WS2812 Led Strip : Yes
  • Beeper : Yes
  • RSSI: Yes

Features​

  • 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
  • 7x PWM / DShot outputs without conflict
  • 5x UARTs
  • 1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
  • 1x I2C1
  • 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
  • 1x Side-press button for BOOT(DFU) mode
  • 1x 16pin bottom mounted FFC Slot for FCHUB-6S or FCHUB-VTX connection
  • 36x36mm PCB with 30.5mm mounting holes

Ships with 2x 0.5mm*16Pin 5cm Flexible Flat Cable and 4pcs M3 Anti-vibration Standoffs

Manufacturers and Distributors​

Designers​

Matek Systems www.mateksys.com

Maintainers​

  • Hardware: Matek Systems

Tips​

  • Included rubber anti-vibration standoffs are necessary to avoid vibration issues.

FAQ & Known Issues​

Setup Guide Matek F722-STD: http://www.mateksys.com/?portfolio=f722-std#tab-id-3

Rcgroups Thread Matek F722: https://www.rcgroups.com/forums/showthread.php?2986161-Matek-Flight-Controller-F722-STD